Alfra MBS PRO TCT hole saw
These high quality hole saws are manufactured in Germany and made from Tungston Carbide for excellent durability.
The MBS PRO’s triple thickness wall construction and wide flutes for chip removal will make any job easy to cut in carbon steel materials up to ¾" inch thick and to 5" in diameter. This is the only hole saw specifically engineered for drilling holes in thin gauge stainless steel (10-12 ga. SS). If you are drilling stainless steel enclosures it is HALF the cost of doing the same hole with a punch and die. The saw and pilot guide drill last for the life of the cutter and you can easily drill over 80 holes in 12 gauge stainless steel enclosures. In carbon steel you will get hundreds of holes using just a good half inch drill. Suitable for flat materials but also pipes and curved surfaces. Cutting of overlapping holes is possible.
- Maximum cutting depth of 20mm
- Equipped with ejector spring to self eject the cut material
- Tapered center drill with pre- and post-cutter Centering without running off (center punching not necessary)
- Can be re-sharpened
Shipping Policy: Our policy is not to charge any extra for shipping. All of our shipping is done via UPS ground, and the shipping is calculated with a UPS daily pickup rate with no additional handling or service changes.
Typical delivery time is within two to three days.